This product uses av interface / more practical
Image sensor: PC7070
Image format: NTSC/PAL
Diagonal viewing angle: 170 degrees
Resolution / 640 x 480
Backlight compensation / power-on start Sensing area / 4.9 x 3.7
Number of LEDs 24
Night vision distance 3 - 5 meters
Output model amplitude 75 ohm
waterproof rating / IP66 Note is rain
Rated voltage: DC12V - 24V
Designed for automotive rear view research and development, waterproof, dustproof, rain, car wash, etc.
Do not worry about using digital fill light and software technology, daytime images are clear, night infrared night vision is strong.
Viewing angle 170-degree large viewing range, safer reversing -20 Deg.C to +70 Deg.C temperature application range, fully in line with automotive environment applications.
The obstacles are at a glance. The digital sensor is processed at a glance. The night vision effect is obvious.
The factory is subjected to high-pressure water immersion test and 12-hour power-on aging test.
The multi-layer waterproof design is truly high-pressure rinsing and immersion waterproof installed at the high end of the vehicle.
Connect the taillight power supply of the car. When reversing, the reversing monitoring system will start working automatically, and the rear of the car can be clearly seen.
The situation is generally applicable to trucks, trucks, bus, forklifts, harvesters, cash cars, fire engines.
Mining trucks, lifting transport, dock forklifts, trucks, garbage trucks, tank trucks, concrete trucks, trailers, school bus, coaches, etc.
Installed at the rear handle and license plate light Installation instructions .
The video cable is connected to the monitor, the power cable is connected to the taillight power supply, and when the vehicle is reversed, the reverse monitoring system automatically starts working, and the situation behind the car can be clearly seen.
Steps for installing the reversing camera:
The first step is to first remove the power supply connection at the vehicle battery and place the removed wiring away from the electrode to prevent the power supply from being accidentally connected.
The second step to determine the installation position of the car camera is generally divided into two types: one is installed in the position of the license plate license plate light, this installation is relatively easy, just use the small screws provided in the camera accessories to fix the camera to the license plate light The location is fine. Adjust the iron or gasket in the accessories to achieve the best reversing angle of the camera. The line of the camera penetrates into the car through the gap of the license plate lamp, and is connected with the backup lamp power supply and the video extension cable. This type of reversing camera is a popular one, with a more subtle appearance and easier installation. The other is a drilled installation that fits inside the bumper. The advantage of this method is that there is no need to drill holes in the metal parts behind the car. Because the bumper is a plastic piece, the camera is also relatively easy to route.
Connect the power cable of the camera to the power cable of the rear backup lamp. Then connect the video cable of the camera to the video extension cable, and connect the other end of the video extension cable to the AV input of the car display. Finally, restore the battery power supply, start the car, hang up the reverse gear, you can see the reverse image on the car display.
Matters needing attention:
1. Can not completely rely on the reverse rear view system to reverse, but can only be regarded as an auxiliary tool for reversing.
2. The car display must be properly connected. If the display does not provide an AV input interface, you must find the corresponding video cable or add a video switching device so that the rear view image is displayed normally.
3. Do not easily connect the car electrical power directly to the car battery power supply, so as not to cause power instability