CRIUS Side Pin All in One Pro Flight Controller V2.0 with Logic Level Converter

With side pins
Supported MegaPirateNG / ArduCopterNG ArduPlaneNG / MultiWii / AeroQuadand firmware
Up to 8-axis motor output
8 input channels for standard receiver and PPM SUM
4 serial ports for debug / Bluetooth Module / OSD / GPS / telemetry
2 servos output for PITCH and ROLL gimbal system
A servos output to trigger a camera button
6 Analog output for extend device
A I2C port for extend sensor or device
Separate 3.3V and 5V LDO voltage regulator
Built-in 16Mbit data flash memory chip to record the data automatically
ATMega 2560-16AU Microcontroller
MPU6050 6 axis gyro / accel with motion processing unit HMC5883L 3-axis digital magnetometer
MS5611-01BA01 highprecision altimeter
FT232RQ USB-UART chip and Micro USB receptacle
On board logic level converter

Input Power Selection:
One of the following ways
Connect 5V power cable from ESC or UBEC to the ESC/Servo port, the J1 jumper must be closed
Connect 5V - 12V power cable to the extend power port, the J1 jumper must be removed
When using extend board, AIO PRO must be powered from the extend power port