DIY E-cigarette coil winder kit winding machine wire clone coiling tool E-cig tool coiler
4 sizes of coiling pins (2.0 / 2.5 / 3.0 / 3.5mm) with hexagon wrench and screwdriver heads(CROSS + SLOTTED)
Simply trap your wire, rotate the top cap, and you get that perfect micro coil in seconds
Light weight and portable, perfect for traveling, and on the go
Come with 2 screwdriver blades and hexagon wrench for additional functionsHow To Use:
Insert the socket screw into the appropriate hole of the winder section.
Insert wire through hole on the side of the handle. Leave about of the wire protruding from the hole.
Hold the end of the wire against the handle so it won't pull through.
Pull the loose end of the wire around the shaft.
Slide the winder section over the shaft with the pin facing toward the handle.
Turn the winder section so that it catches the wire and starts wrapping it around the shaft.
Keep light pressure against handle while winding.
Excessive pressure will force smaller gauge wire to wrap over itself.
When finished, remove winder and straighten the wire end that protrudes from the hole in the handle.
Push up on the wire to slide coil up. Carefully grab the coil at the bottom to slide it off the shaft. NOTE:
The coiler winds the coils with the loops touching each other. This can initially give wrong resistance values without first burning in the coil. Care must be taken when first firing the device with a new coil. Carefully pulse the device to bring temperature upo slowly so you do not create a "hot leg" and melt the coil. Rake the coils lightly in between pulsing to improve the break in process. Pre burning or oxidizing the wire before making the coil may also help.