HAKRC F722 Flight Controller OSD BEC 5V / 2A 9V / 2A 3 - 9S ESC - Black

Main Features:
● There are many integrated functions of the flight control, and the components are very dense. When installing, please do not use tools ( such as needle-nosed pliers or sleeves ) to screw the nut, which is easy to scratch the tower hardware and cause unnecessary loss. The correct way is to tighten the nut with your fingers and the screwdriver can quickly tighten the screw from the bottom. ( Remember not to be too tight, so as not to damage the PCB )
● Do not install the propeller when installing and debugging the flight control. Try not to fly indoors to avoid safety accidents. Before installing the propeller test, check again that the motor is turning and the propeller is in the correct direction. Safety Tip: Do not fly near the crowd. The company is not responsible for any loss caused by the crash of the aircraft.
● Do not use non-original aluminum or nylon columns to avoid damage to the flight control hardware. The official standard is a custom-sized nylon column for the fly tower.
● Before the power is turned on, please check whether the installation between the towers is correct ( it must be arranged with the pins or cables aligned ), check whether the positive and negative poles of the welding are correct, and check whether the motor screws are against the motor stator to avoid short circuit.
● Check if there is any solder on the electronic parts of the tower, which may cause a short circuit. If the short circuit occurs in the installation, the buyer is responsible for it.

Flight control
Mounting hole distance: 30.5 x 30.5mm/φ4mm
Processor: STM32F722RGT6
Gyro: MPU6000
B E C: 5V/2A; 9V/2A
Memory: 16MB
Input voltage: 3 - 9S
Firmware: BetaFlight - 3.5.5 - HAKRCF722
Uart serial port: 5

ESC
Fixed hole distance: 30.5 x 30.5mm/Φ3mm
Continuous current: 50A
Maximum current: 65A ( sustainable 10S
Input voltage: 3 - 6S

Hardware performance
The HAKRC 50A ESC uses the STSPIN32F0A 32-bit high-performance processor
The original imported MOS tube is used, and the double MOS is connected in parallel to make the heat generation lower
PCB board adopts 3OZ copper thick multi-layer board for stronger overcurrent
5V/3A BEC output, support voltage return and current data transmission
Drive signal support: Dshot150 / 300 / 600 / 1200, Multishot, PWM, Oneshot

Note: The accessories in the picture are included.