Launch our Cool Free App!
Get $3 Off 1st Order.
220V 300W Mini Heat Gun with Stand Hot Air Blower Portable Electric Soldering Tool for Home DIY Crafts Embossing Plastic Packaging Electronics Repair
Package: 1pcs Heat Gun+ 1pcs Knife +5pcs Blades +2pcs scraper
- Can be used to heating relief powder and shrinkable sheet
- Keeping 3-5cm distance from work and about a 45 degree angle to heat until it is completed.
- After completion, use the heat gun at high temperature to blow a few minutes,
- it not only can add its hardness, but also its brightness
- The temprature can not adjustable, in theory, it can reach at 200 degree within a few seconds
- Do not work over 10 minutes, blow at 45 degree angle to avoid heat suck.
- Be carefull when using
Temperature at nozzle outlet approx : 60 ºC /150 ºC / 210 ºC
Rated Power: 300W
Rated voltage: 220V 50-60Hz
Plug Type: EU Plug
Function : Low temperature heating appliations (eg.forming of plastic,drying of paper
materials . warming of the heat-shinkable tubing) .It is not suitable for solderind and tinning.
For Y our S afety
Working safely with this unit is possible only when the operating and safety
information are read completely and instructions contained therein are stricktly followed.
。The unit must not be damp and must also not be operated in damp ，rain
and explosive surroundings.
。Before each use of the unit,check the cable and plug.If damage is detected,do
not use the unit.Have repairs performed only by a qualified technician,never
open the unit yourself.
。Do not carry or hang up the unit by the cable.
。Do not point the unit for a long period at one spot.
。Allow the unit to cool completely befor storing.
。Never allow children to use the unit.
P utting into O peration
Always use the correct supply voltage!
The unit designated for AC220V, can also be operated with AC230V.
。Set the switch on position 0 .
。Plug in the unit.
。Hold the unit ,always direct the cable to the rear away from the unit.
。Toggle the switch to I or II position .Position I ,lower air temperature and
flow.But position II much higher . Heater on/off button decide the
。Keep 5-6cm between the unit and the item,do not use more than 15 minutes.
。Before shut off ,push the heater button,cooling down 30 seconds.
。Toggle the switch on position 0.