4xTMC2208 Stepper Motor Driver TMC2100 MKS replace for 3D Printer - Golden brown

4 x TMC2208 Stepper Motor Driver TMC2100 MKS replace for 3D Printer

Product advantages: quiet, super quiet, super super quiet
Product Description
TMC2208 V1.0 Feature:
1. The spreadCycle high chopping frequency, dcStep, stallGuard2 blockage detection technology.
2. The coolStep dynamic current regulation technology, can save 70% of energy, StealthChop mute.
3. TRINAMIC's stepper motor driver (chopper drive / constant current drive).
4. Automatic standby current reduction.
5. Microplyer - subdivision interpolation subdivision smoothness increase.
6. Stealthchop - quiet operation and smooth action.
7. Spreadcycle high dynamic motion control chopper

TMC2208 V1.0 Specification:
Model: TMC2208
Current: driving current: 1.4A Crest value: 2A
Voltage range: 4.75V-36V
Subdivision: 256 subdivision
Product weight: 4g

Warm Tips:
1. Please make sure that the positive and negative are connected reversed before the electricity is connected. If it is burned by the user, we do not guarantee this kind of problem.
2. Please do not plug the motor and drive in the case of electricity. It is easy to cause the drive to burn; and do not adjust the current during the operation of the motor.
3. The right way is to disconnect the power, remove the motor, re-power up, adjust potentiometers, and measure the voltage on the potentiometer until the measured voltage is the same as expected.
4. Do not plug in the reverse drive, otherwise it will burn the drive, and even burn the motherboard!
5. Motor drive is not included.
6. It is possible to burn down the chip and circuit by the reverse of the power supply. Please turn on the electricity again and again.
7. Do not connect the motor when measuring voltage, otherwise it will easily burn the drive.
8. Turn on the power when measuring voltage, not just connect USB power.
Please pay special attention to the direction, do not insert it! ! !

Note:
Please allow 1-3mm differs due to manual measurement.
Due to the different display and different light, the picture may not show the actual color of the item. Thanks for your understanding.
Included:
4 x TMC2208 V1.0 Stepper Motor Drivers(It has been welded on the main board)
4 x Heat Sinks
2 x Screwdriver