Launch our Cool Free App!
Get $3 Off 1st Order.
Unit Box Dimension:9.25" x 3.40" x 3.00"
Dispenser Dimension:8.50" x 2.50" x 2.50"
Installation using screws and anchors:
1. Select the desire mounting location.
2. Hold the dispenser or mounting plate against the wall. Mark the screw hole locations on the wall.
3. Pre-drill mark holes with 7/32” drill bit.
4. If mounting on dry wall. Use the provided wall anchors.
5. Tighten screws firmly.
Adhesive tape mounting: (Please allow 4 hours to set before use)
1. Apply the provided adhesive tapes of the back of the Single dispenser or Mounting plate; (see shown on pictures below):
2. Determine the mounting location. Recommended to mount away from direct water contact.
3. Use the provided alcohol pad to clean the mounting surface throughly. Allow the surface to dry.
4. Apply the provided Silicon Glue to the void areas around the adhesive tapes. Remove the backing on the adhesive tapes
5. Firmly press the dispenser or mounting plate against the desired location surface. HOLD for 30 seconds.
6. Wait 4 hours for the Adhesive tapes and silicon to set before sliding the dispensers back on to the mounting plate.
warm tip:I strongly advice everyone to use screws to mount the product, as 3M Double-Sided Wall Mounting Tape will fall overtime whatsoever.