Launch our Cool Free App!
Get $3 Off 1st Order.
1. The Ender 3 ABL kit is only for the complete automatic bed leveling kit for the Ender 3 Ender 3 PRO 3D printer.
2. Suitable for all printed surfaces, glass, aluminum substrates and removable building surfaces.
3. Complete and simple flash firmware and installation instructions, with all required software and compiled binary .hex files.
4. Capacitive sensor can be used on any printed surface
5. Pre-wired electronic equipment can be placed in the custom enclosure
6. Our sensors are optically isolated, so even when failure occurs , you will not have the risk of burning down the printer's motherboard, which is different from the diode or resistor settings.
7. The sensor has been connected to the optical isolation module, you only need to connect 2 wires and replace the Z-min connector.
8. Including an icsp programmer for programming firmware.
9. U disk content: firmware, burning software, installation and use instructions, drivers, etc.
10. Our sensors are photoelectrically isolated, so unlike diode or resistor settings, you don’t have to risk burning the printer’s motherboard when a fault occurs.