Launch our Cool Free App!
Get $3 Off 1st Order.
How to ugprade old screen into new screen for Ender 3, Ender 3 Pro, Ender 3S(only support motherboard version 4.2.2 or 4.2.7)?
Step 1: Power off your 3d printer.
Step 2: Remove the old knob screen.
Step 3: Remove the old knob screen cable.
Step 4: Plug one end of cable to new screen.
Step 5: Tighten 3 sets of T-nut and screw on the chute, but please don't tighten them completely.
Step 6: fix the chute on the side of the bottom profile.
Step 7: Plug in the other end of the screen cable to mother board.
Step 8: Refresh the firmware: Please visit Creality offical download page, download the Ender-3 series screen firmware. Store to a blank TF card.(Ender 3 V2 no need to refresh firmware, just replace the old screen.)
Step 9: Insert the TF card to your printer.
Step 10: Turn on your printer, wait a few seconds for the firmware to install.After finished, then you can start printing.
1 × Knob Screen Kit
1)The screen can not work with 8 bit (V1.1.4 and V1.1.5) motherboard.There is no open source firmware for this screen now, the firmware can't be edited or customemized.
2)This screen works for Creality Ender 3 V2/Ender 3/Ender 3 Pro/Ender 3S with 32 bit V4.2.2 or V4.2.7 mainboard. Please don't use it for other printers.
3)This screen can't be used together with filament sensor.